Material :Â bass CZ122Â CW602NÂ CW671N DZR brass
Working pressure :  2.0Mpa
Tested Pressure :Â 2.5Mpa
Working medium :Â Water, oil, gas
Working temperature : -20oC≤ T≤ 150oC
Thread :Â BSP & NPT thread.
Brass ball with chrome plating
Â
We can produce according to your design as well.
Water Meter Accessories,brass ball valve for flow meter ,brass ball valve,brass nipple,brass expansionMaterial :Â bass CZ122Â CW602NÂ CW671N DZR brass
Working pressure :  2.0Mpa
Tested Pressure :Â 2.5Mpa
Working medium :Â Water, oil, gas
Working temperature : -20oC≤ T≤ 150oC
Thread :Â BSP & NPT thread.
Brass ball with chrome plating
Â
We can produce according to your design as well.
Electric hydraulic portable light weight portable volume small far-light screw steel hand-held Steel Bar Cutting Machine
The steel Bar Cutting Machine is a kind of tool used to shear steel bars.
There are automatic steel cutting machine and semi-automatic steel cutting machine.
It is one of the necessary equipment for steel rebar processing, and it is mainly used to cut off the length of rebar in buildings, Bridges, tunnels, power stations and large water conservancy projects.
Compared with other cutting equipment, steel bar cutting machine has the characteristics of light weight, low energy consumption, reliable operation and high efficiency.
There are automatic steel cutting machine and semi-automatic steel cutting machine.
The fully automatic cutting machine, also called electric cutting machine, is used to control the cutting knife incision through motor transformation into kinetic energy to achieve the effect of shearing steel.
While semi-automatic is manual control of the incision, so shear reinforcement operations.
And more should belong to hydraulic steel bar cutting machine bar cutting machine is divided into charging type and portable two categories.
Electric hydraulic steel bar cutting machine mainly consists of motor, hydraulic transmission system, control device, fixed blade and so on.
Working principle: the motor drives the eccentric shaft to rotate, the eccentric surface of the eccentric shaft to back and forth motion with the plunger in contact with it, so that the plunger pump produces high pressure oil into the cylinder body, drives the piston in the oil cylinder, drives the moving blade forward, and cuts off the steel bar by phase with the fixed blade fixed on the support.
The hydraulic system of manual hydraulic steel bar cutting machine is composed of piston, plunger, hydraulic cylinder, pressure lever, pin pulling, reset spring, oil storage barrel and drain and oil suction valve.
Portable Rebar Cutter,Rebar Cutter,Electric Rebar Cutter,Hydraulic Rebar Cutter
Shandong Luteng Building Equipment Co., Ltd. , https://www.lutengmachinery.com