Initially determine the displacement coefficient of the large gear x02x02=Wmin-W2msin(1) or x02=Smin-m22mtan(2) where: W is the common normal length of the standard gear with the same measured gear parameters, mm; W=mcos[( K-05) Zinv], k=180Z 12; Z number of gears to be measured; k-to-tooth number; m modulus of the gear to be measured; indexing circle pressure angle; Smin minimum graduation measured on the worn large gear Round chord tooth thickness (approximate to the indexing scallop thickness), mm.
Check whether the big gear is undercut xmin=Zmin-ZZminha(3)Zmin=2hasin2(4) where: xmin does not cut the minimum displacement coefficient; Zmin standard gear does not cut the minimum number of teeth; ha tooth top height coefficient.
Uncut conditions: x02xmin(5) When the formula (5) is established, the large gear can also be repaired. When the formula (5) is not established, the large gear wear is too serious and cannot be repaired.
The gear is re-cut with a negative displacement. After the tooth displacement coefficient x02 is determined according to the formula (1) or (2), the large gear is re-cut with a negative displacement. The processed negative displacement large gear must ensure all the teeth. Cut off the traces of wear on the entire tooth surface. Otherwise, increase the displacement coefficient x02 (the absolute value of x02) and re-cut the teeth. At the same time, the displacement coefficient x2 of the large gear should be recorded and checked according to equation (5). Must be guaranteed not to be cut.
Calculate the transmission size according to the equal-gear displacement gear transmission, refer to the mechanical parts design manual or mechanical principle to calculate the size of the gear.
Known parameters: modulus m, number of teeth Z, indexing circle pressure angle, tip height coefficient ha, radial gap coefficient C, displacement coefficient x1 = -x2.
Index circle diameter: d1=mZ1, d2=mZ2; top height: ha1=(ha x1)m, ha2=(ha x2)m; root height: hf1=(ha C-x1)m, hf2=( Ha C-x2)m; tip diameter: da1=d1 2ha1,da2=d2 2ha2; root diameter: df1=d1-2hf1, df2=d2 2hf2; center distance: a=1/2m(Z1 Z2) The length of the common normal line: W=mcos[(k-0.5) Zinv] 2xsin; the number of teeth across: k=180Z 0.5 2xcot6 formulated pinion re-machined with a positive displacement according to x1=-x2, paired with a modified large gear gear. The size of the pinion must conform to the dimensions calculated above and the given parameters.
Cut to Length Line is used in the Metal materials cutting.
Hangzhou Yibo Machinery Co.,Ltd, founded in 2003 is an professional machinery manufacturer for design, produce, service and trade.
Yibo's main products are Cold Roll Forming Machine, such as purlin Forming Machine , guardrail forming machine, roof panel forming machine, wall panel forming machine, tile forming machine, floor Deck Forming Machine, Roof Seaming Machine and so on; steel coil process machinery such as Slitting Line , cut to length line, combined line and so on; accessory Stamping Parts such as roof supporting clips, connect bar, water bar and so on.
Cut to Length Line
Cut to Length Line,Cut to Length Machine,Cut to Length Line Machine,Cut to Length Process Line
HANGZHOU IUWON TECHNOLOGY CO,. LTD. , http://www.iuwon.com