The weather conditions in the summer season are all changing. The sun can squeeze people out of the oil, and there may be thundery thunderstorms. Therefore, under such seasons, the focus on the maintenance of road sweepers is more relevant to the sanitation department and car owners. Because of the relatively high temperature, due to frequent use and the comparison of the load of some system devices, the lubrication system, the air conditioning system, the cooling system, the tires, and so on, will all cause a failure. Therefore, in addition to the road sweeper vehicle maintenance should be carried out on a regular basis, but also need to special maintenance of a system and spare parts, all the fault germination are prevented thousands of miles away. In the summer, the working hours of road sweepers will also be longer. In high-temperature weather, it is also necessary to carry out continuous high-load work. People will have summer heatstroke prevention during the summer days, and the sweepers will continue to work for a long time. It is also necessary to make inspections and maintenance. In summer, vehicle air conditioning is a must-have. To make the air work better, it is best to perform a “cleaning†of the entire air conditioning system. The road sweeper works in such a climate. Because it has different operating environments from other seasons, it is necessary to pay attention to the following important matters.
1, not only people are afraid of being sunburned by ultraviolet rays in summer, although the vehicle is only a metal sheet, in fact, it is also very afraid of exposure. If the road sweeper is exposed to a long time, it will cause paint damage, and It will speed up the aging process of some interiors. When cleaning the sweeper, the tanks can be cleaned together and the debris attached to them can be removed. This will make the engine easier to dissipate heat.
2, summer is also the season of high rain, sweeping vehicles can not avoid the occurrence of wading situation, so it should be to prevent early, so as to avoid vehicle failure. The owner of the road sweeper needs regular inspections of several items on the vehicle, checking the tires, checking the sealing of the strips, checking the chassis, and checking the drains.
3. When the temperature is relatively high, the driver should not allow the vehicle to work for a long period of time. It is necessary to avoid the tires from being subjected to high temperature friction with the ground for a long time. As shown in the relatively high temperature conditions, the heat dissipation of the wheels will be relatively slow, and the tire inflation will be caused by the increased tire pressure. Therefore, it is also necessary to check the tires in summer.
4. The most important protection work in this season is to prevent the spontaneous combustion of road sweepers . In the summer, the occurrence of auto-ignition accidents of the vehicles is higher than the probability of occurrence of other times. There are many reasons why a vehicle can cause spontaneous combustion. There are air holes in the fuel tank cover of the vehicle. If the mailbox is too full, the fuel will overflow when the vehicle is jolted during driving. If there is an open flame and static electricity, it will cause a fire.
we are plastic Injection Mould company which also provide Mechanical Design ,Mechanical engineering and design software helps engineers and designers visualize, analyze, and communicate design intent before building a physical prototype. Mechanical engineering software is employed across an array of disciplines, from manufacturing and architecture to sustainability. It`s used to design everything from cars to prosthetics to headphones. Each product starts as a concept, which can take the form of sketches, specifications or constraints that dictate design requirements. A product designer, or usually a team of product designers and engineers, then takes the concept and, using mechanical engineering software, turns the concept into a comprehensive product design. The final design must be manufacturable-that is, be able to meet manufacturing requirements, such as the ability to withstand specified stresses and strains while minimizing the final product`s weight. This design phase can take several iterations and refining. It can also include a design simulation phase, using software that tests and validates the product design before the final step of manufacturing.
Mechanical Design
Mechanical Design,Mechanical Engineering Product Design,Rapid Mechanical Parts Processing,Computer Speaker Odm Mould
Topwell Spring Development Ltd. , http://www.topwelldesign.com