We all know that during the operation of a CNC flame cutting machine, there is a state called continuous cutting. The so-called continuous cutting refers to the process of cutting dozens or even hundreds of parts without lifting the nozzle after the cutting plate cuts a cutting hole. Under the current technical conditions of domestic CNC flame cutting machines, if long-term continuous cutting can be achieved, cutting efficiency and material utilization can be improved, and the company's production costs can also be reduced. Therefore, the majority of users of CNC flame cutting machines can use the CNC cutting machine to try continuous cutting.
How can we achieve continuous cutting? Wuhan resistance to tyrants CNC to give our customers a brief introduction:
First of all, we must understand that in order to achieve continuous cutting, we must adjust the location of the introduction of the leader. The method is: in the output NC state, [move the entry point] to change.
Secondly, set the bridge's cutting short-distance line to the [checked] state, and confirm the shortest distance [short run length] value between the previous lead-out line and the next workpiece introduction line;
Again, the distance between the lead of the first work piece and the lead-in of the next work piece should be less than the value of the [short run length] in step 2;
Finally, ensure that there is no obstacle in the contour of the workpiece between the lead of the first workpiece and the lead of the next workpiece;
What we call continuous cutting refers to the method that can be considered when users need to load large quantities of steel sheets. The use of continuous cutting can not only improve the board utilization rate and cutting efficiency, but also can insist on the cost of the company. Of course, there are other ways to realize continuous cutting in addition to the above methods. We will continue to explain it to everyone in the future.
Chinese cutting machine trading network, allowing you to buy the rest assured! A variety of CNC cutting machine and CNC cutting equipment, a variety of cutting machine models, let the optional! Official website: /
1. Naipu Pump offers all elastomer rubbe wet parts.The high chrome white iron is a very good wear-resistant material and nice wear-resistant is our slurry pumps important character.For the corrosive slurries with blunt particles, we recommend the natural rubber.
2. Material of Slurry pump wet end parts:
Natural rubber,butyl,neoprene,hypalon,etc.
Slurry Pump Parts,Rubber Slurry Pump Parts,Slurry Pump Rubber Parts,Slurry Pump Impeller
Shijiazhuang Naipu Pump Co., Ltd. , https://www.naipu-pump.com